Ability to check if wheels, control surfaces, hinges, etc are setup correctly
Example:

It would be great if we could see that everything is configured correctly before flying or launching. Often times, I've built a plane only to realize that the rudder and horizontal stabilizer were inverted. Wheels as well when they were off by 90 degrees.

Suggestion Active

13 Comments

  • Log in to leave a comment
  • Profile image

    Good idea

    11 months ago
  • Profile image
    134 mundindel

    👍 badly needed !
    In addition to plain convenience, it will greatly increase launch success rate, which will be a big step toward not using UNDO option at all.

    +2 1.6 years ago
  • Profile image
    Dev Pedro

    This post has been merged with this post.

    2.8 years ago
  • Profile image
    Dev Pedro

    This post has been merged with this post.

    2.8 years ago
  • Profile image
    5,066 AgniteSpace

    Yesssss,tooooo much annoying

    +2 3.4 years ago
  • Profile image

    I've had this exact same problem, and it's just very annoying and a pain in the ass to deal with.

    +2 3.8 years ago
  • Profile image
    13.7k CardZlol

    what about moving hinges on the designer
    thatd be cool

    +3 3.8 years ago
  • Profile image
    Mod Mostly

    To be honest I was a little disappointed when I found out this game didn't have something like this - since SP already has the feature.

    +2 3.8 years ago
  • Profile image

    🅱lane

    3.8 years ago
  • Profile image

    This would be especially useful for mfds

    +3 3.8 years ago
  • Profile image
    727 Ardee

    @jrzspace Exactly! Specially on low end devices like mine, load times can take 10-15 seconds on that loading screen. So this would be great

    +1 3.8 years ago
  • Profile image
    1,161 jrzspace

    That would be cool. It's a waste of time realizing that your configurations are wrong during flight time.

    +3 3.8 years ago
  • Profile image

    Would also be useful for rotators, pistons, and motors

    +4 3.8 years ago

60 Upvotes

Log in in to upvote this post.