Warp did not go to normal speed after 2 or 3 repeated burn nodes, the warp stays at X10 speed and the engine auto-burn never starts, here you can see the craft flying away from the moon due to auto-burn not performing.
not sure if it can be repeated but in my sandbox you can try:
1-sest auto-burn from earth to moon or to enter lunar orbit
2-begin node as normal
3-when craft time-warps to node the warp does not go to normal speed but goes to X10 and engines do not burn
| View |
@KraZIvan How often has you seen this happen? For now I am going close this report, but if you come up with a way to reproduce the issue, I will re-open it.
@AndrewGarrison I don't use more than 1 burn node at a time to avoid thism so I don't think that's it, I've asked others and they don't seem to encounter this either. I'll try to gather more info if I encounter this again.
Is it possible your burn nodes were overlapping in the sense that their required burn time of the second burn node would overlap the arrival time of the first burn node? I cannot reproduce this issue, but any more information would be helpful.
@PhilipTarpley I suspect this bug is due in part to my laptop being old, there is some input lag sometimes and I think this causes the burn node to not have enough time to bring the time warp down to X1 (when the bug occurs the time warp gets stuck at X5) and so the burn does not occur correctly (a workaround hase been to keep my finger on the time warp key and press it if I see this happening). Again I think that is due to the input lag caused because of my laptop. If I'm able to catch this happening on video I'll make sure to post it.