I am not sure how to reproduce, but editing tinker panel managed to split a part into "2". After editing a wing, to adjust its dimensions in tinker panel, the original untinker'd part remained, but the tinker'd part was placed in the exact same spot. So now moving the tinkered part has no issues, but trying to remove the "artifact" results in moving the tinkered part??????????? This is so wierd??????
Bug
Rejected
Found in 1.2.210.0
| View |
4 Comments
- Log in to leave a comment
-
Dev Pedro10 months ago
@Welliedowner It is hard to tell what the starting point was, the part duplication is the result of an internal error andthe logs have a bunch of errors that could result from non allowed attachments, invalid hiden part property tweaks or a rare and hard to repro bug.
Sadly I can't trace it back to anything in particular, if you run into this again, another report would let me compare the logs and see what is in common, so it'd be appreciated.
-
764 Welliedowner10 months ago
@Pedro did i??? i dont remember changing anything but the tip position and root and tip leading and trailing offsets. I dont think i changed those values myself, unless i removed cast shadows but i dont remember doing that.... i dont think i did it myself. But correct me if im wrong
-
No Upvotes
Log in in to upvote this post.
@Pedro No worries, on the lookout