Rotowing Ex-1

Talk about rotating wing aircraft, heh.
This thing is a bit tricky to fly, near impossible to be honest, so here let me try to give you some instructions :

1. As you can see, in the first picture is sitting on its tail with the wings already rotating. This can be done by using the slider 1 to turn the wings either way.

2. In picture two, you see it fly, or well, take off. To archieve that you gotta slightly move the slider back to the center, but not all the way, or you wont be able to use the wings in a rotor like way to lift yourself up. Once in flight you can move slider 1 almost back to the center, so that the wings keep spinning and wont stop.

3. In the third picture you see it with its wings bent upward, not spinning. To archieve this you have to set the slider 1 to absolute zero, and use slider 2 to make the wings bend upwards, they go as far as 90 degrees. Then pull up, due to them now being upward they'll even themselves out, turning is a bit different now since they still spin freely. If you want to land somewhere i'd recommend doing it this way, and keep your nose up on approach or the wings wont self level.

4. In the fourth picture you see it landed on the ground, if you have followed my pathetic attempt at instructions and have sacrificed your soul to satan in order to get this done, congrats.

Additional info, the landing gear on its tail retracts with group 7, the normal landing gear on its belly retracts with 8.
Oh and if you want to start normal, the capsule part is located between the front landing gear, you need to manually rotate the plane 90 degrees in the designer

Good luck flying this abomination