[RSS] Hongyan-1 Venus probe

Introduction to the detector

Hongyan-1 Venus probe was launched using the LPE-I 2NS configuration, consisting of two parts, an orbiter and a lander

1. Orbiters

It is equipped with many instruments, such as atmospheric Lidar, atmospheric profile radar, magnetometer, etc., to provide attitude and orbit control for the assembly after separation from the LPE-I to the lander before separation, and to provide relay communication between the lander and the ground after separation from the lander

2. The lander

consists of a back cover and drone. The back cover provides the drone with thermal protection and parachute deceleration during re-entry. Venus's thick atmosphere is perfect for drone flights.

Activate the group

AG 1: automatic launch program

AG 2: Water spray noise reduction

AG 3: Tower light

AG 7:Hongyan-1RCS

AG 8: Drone light

AG 9: Orbiter solar panel

AG 10:LPE-I RCS

How to use (automatic launch program only)

1. Press AG 1 to start the launching program and enter the data according to the screen requirements. After completion, you can select the appropriate launch window to launch, or directly launch. To prevent miscontact, press AG 1 again to confirm the launch procedure after data entry

2. Wait for SRB fuel to run out and separate SRB (no program control)

3. Wait for the assembly to enter the predetermined orbit (with a certain deviation)

4. Manually establish the Venus transfer orbit and other subsequent operations

Note:

Due to the high temperature and pressure of Venus, there is a certain chance that the drone will explode

The probe could also carry out missions to Mars

ps: This is my first time to do a drone, not very good, please forgive me

Have a good time!