Tianwen Mars Lander

This work has passed the earth test.Hello everyone, I am here again. This time I brought the Tianwen-1 landing assembly, which consists of a lander, a protective cover and the Zhurong rover I made before.

In the design, I borrowed the landing combination of China Tianwen One, but it is not real, at least not the size, but I completely used the method of China Tianwen for the landing method.

Its lander is like a table, composed of four landing legs and a platform. Above the platform is installed an orbit for the rover to descend to the Martian ground. Although there is no friction between the parts in the game, I still try to restore it as much as possible. Up this track.

Below the platform is a reverse thrust engine, used for deceleration in the final stage of landing. At the same time, there are 20 RCS nozzles installed at the four corners of the platform. Together they form a set of attitude stabilization system. In actual tests, they perfectly worked.

On top of the lander is the rover I made before. In this work, I have placed it directly in the shell. If you need a separate rover, you can check the posts I published in the past.

On the outside of the lander is a protective cover. On top of it is a parachute. The parachute is protected by a separate protective cover. During the descent phase, when you open the trim wings, the parachute protective cover will automatically open, which means you are about to Enter the parachute deceleration phase.

Below the protective cover is a heat shield, which has been experimentally proven to block the high temperature when it reenters the earth’s atmosphere.

There is a trim wing on the shell of the protective cover and 4 RCS nozzles for attitude control when entering the Martian atmosphere.

This lander must be used with the Mars rover I made before, otherwise unknown problems will occur. Of course, it is completely feasible if you want to launch only the lander.

If you need to use this work for creation, please indicate the author, thank you.