TCS-Lenticular Cloud-1-C

Right, now. I think maybe your computer did something wrong. So I copied it into notepad and copy to Comments again.

This is an unmanned lunar probe, it carries an antenna, infrared detector, laser meter (analog). More will be posted in the comments section below.
This unmanned lunar probe brings its own rocket. Of course, you can also assemble your own rockets for it. The probe's landing mode is turned on by "1", and the laser meter and the infrared detector at the bottom will be activated. After a smooth landing on the ground, turn off "1" and turn on "2" to activate the detection mode, and the antenna above and the infrared detector will be activated. Adjust the "slider1" so that the upper detection part starts to rotate and scan.
How to use its own rocket? After the rocket launched, wait until it rise to two kilometers, and you should set pitch to 45 degrees before continuing to rise. When the booster section runs out of fuel, disengage the booster and shut down the engine immediately. When the rocket reaches the apex, you can start the engine again and put the rocket into orbit. Then adjust the orbit to let the rocket capture by the moon's gravity. After capturing, adjusts its orbit to put the spacecraft into the moon's 50-kilometer-high orbit. Select a suitable landing location and activate the landing mode.
How to land the probe? First, adjust the orbit to start landing and activate the landing mode (turn on "1") . Then you need to slow down to 100 meters per second at a height of 20 kilometers. And then turn off the engine and continue to fall. When the altitude lands below 1500 meters, pay attention to the ground, you can find green spots, and you should keep the rocket's speed at 30 to 50 meters per second. When the height is below 500 meters, keep the speed below 10 meters per second. And the landing was finally completed.

Cool craft!!!

I'm sorry, except for some problems on the official website, my introduction can't be displayed normally. Maybe it will be useful to copy it.

This is an unmanned lunar probe, it carries an antenna, infrared detector, laser meter (analog). More will be posted in the comments section below.This unmanned lunar probe brings its own rocket. Of course, you can also assemble your own rockets for it. The probe's landing mode is turned on by "1", and the laser meter and the infrared detector at the bottom will be activated. After a smooth landing on the ground, turn off "1" and turn on "2" to activate the detection mode, and the antenna above and the infrared detector will be activated. Adjust the "slider1" so that the upper detection part starts to rotate and scan.How to use its own rocket? After the rocket launched, wait until it rise to two kilometers, and you should set pitch to 45 degrees before continuing to rise. When the booster section runs out of fuel, disengage the booster and shut down the engine immediately. When the rocket reaches the apex, you can start the engine again and put the rocket into orbit. Then adjust the orbit to let the rocket capture by the moon's gravity. After capturing, adjusts its orbit to put the spacecraft into the moon's 50-kilometer-high orbit. Select a suitable landing location and activate the landing mode.How to land the probe? First, adjust the orbit to start landing and activate the landing mode (turn on "1") . Then you need to slow down to 100 meters per second at a height of 20 kilometers. And then turn off the engine and continue to fall. When the altitude lands below 1500 meters, pay attention to the ground, you can find green spots, and you should keep the rocket's speed at 30 to 50 meters per second. When the height is below 500 meters, keep the speed below 10 meters per second. And the landing was finally completed.

Must say, it's very nice!

Nice