The Soviet N1 rocket (official version)

I've upgraded my N1 rocket with the following improvements:

A more detailed Soyuz module.

Added details to the escape tower grille panels.

Modified and adjusted the layout of the RCS (Reaction Control System).

Reinforced the rover for the second time to prevent it from disintegrating during the rocket's ascent.

Added a connection between the Soyuz and the lunar module to prevent launch failure caused by the disintegration of the internal fairing.

Functions of Activation Groups:

• Activation Group 1: After switching to the lunar module, it can deploy the landing gear.

• Activation Group 2: After switching to the rover, it can start the rover.

• Activation Group 3: After switching to the lunar module, it controls the engine switch.

• Activation Group 4: Separate the escape tower (Note: This is the separation after the escape tower is activated).

• Activation Group 5: No function.

• Activation Group 6: Turn on the gyroscope.

• Activation Group 7: Start the escape tower (After the main engine fuel of the escape tower is exhausted, please click Activation Group 4).

• Activation Group 8: Deploy the antenna and start the docking system.

• Activation Group 9: Deploy the solar panels.

• Activation Group 10: Activate the RCS.

Slider Operations:

• For slider 1, after switching to the lunar module, pull it to - 100 to deploy the landing gear and antenna (It needs to be used in combination with Activation Group 1 and Activation Group 2).

• For slider 2, after switching to the lunar module, it can lift the rover. (To fix the rover and prevent disintegration, many side separation stages are used. First, open the separation stages at the bottom of the rover, including the two separation stages fixing the rear wheels. After lifting the rover, open the two separation stages of the front wheels first, and then open the middle separator, and the rover will drop to the ground).

• After switching to the rover, slider 1 can unfold the rover (Start the rover with Activation Group 2).

My English is not very good, so please forgive me if there are any mistakes.